横吊钢板起重钳 返回列表页

横吊钢板起重钳

采用低碳优质合金钢制造，并经过热处理，性能可靠。
The clamp is made of carbon alloy steel and after forge quenched

小块钢板吊装两只吊钳为一组，大块钢板四只吊钳为一组。
Two clamps in one set for small flat slinging and four clamps in one set for big one.
同时必须采用横梁，进行水平吊运，请参照示意图。
You should better use lifting beam and horizontal lifting at same time.

所吊运钢板厚度应小于开口度5mm。
The steel flat thickness should be under 5mm then jows angle.

不允许几块钢板层叠吊运，防止滑脱。严禁单肢或双肢一侧使用。
One flat only prevent dropping. Can not be use one leg or two legs in one side.

在用三只吊钳水平吊运时，应考虑单只吊钳一侧不能超负荷。
One clamp can not be over load when three clamps are using.