丹阳申澳焊接材料有限公司
丹阳申澳焊接材料有限公司
镍合金的焊接工艺与不锈钢相似，其热膨胀系数与碳钢接近。清洁是成功焊接镍和镍合金的最重要因素。对要焊接的合金来说，焊缝熔敷金属的成分不但受填充金属的控制，而且亦有许多因素必须考虑，如强度、耐蚀性、物理性能和预计的焊缝稀释等。一般原则，的选择应是焊件的强度和耐蚀性要优于母材。
符合GB SNi4060
相当AWS ERNiCu-7
S911是含有少量Mn以及Fe、Ti的镍铜焊丝。耐蚀，可焊性好。
S911 is a nickel-copper welding wire containing a small amount of Mn, Fe and Ti. Corrosion resistance and good weldability.
适用于镍-铜合金本身以及与钢的焊接，也可用于镍-铜合金复合钢覆层一侧的焊接或在钢上堆焊。
It is suitable for the welding of nickel-copper alloy itself and steel. It can also be used for welding on one side of nickel-copper alloy composite steel cladding or surfacing welding on steel.
| C | Mn | Fe | P | S | Si | Ni | Al | Ti | Cu |
| ≤0.15 | ≤4.0 | ≤2.5 | ≤0.02 | ≤0.015 | ≤1.25 | 62.0~69.0 | ≤1.25 | 1.5~3.0 | 余量 |
| 焊丝直径Φ | 1.2 | 1.6 | 2.0 | 2.4 | 3.0 | 4.0 | 5.0 | 6.0 |
| 焊丝长度 | 350；1000 | |||||||
1. 焊前必须清除工件焊接边缘及焊丝表面的氧化物、杂质等。
2.采用钨极氩弧焊时宜采用直流正接。焊较厚板时可以选用熔化极氩弧焊，采用直流反接或交流施焊。
1. The oxides and impurities on the welding edge of the workpiece and the surface of the welding wire must be removed before welding.
2. When using tungsten argon arc welding, DC positive connection should be adopted. When welding thicker plates, argon arc welding with melting pole can be used, and DC reverse welding or AC welding can be used.
您感兴趣的产品PRODUCTS YOU ARE INTERESTED IN
百分零部件网 设计制作，未经允许翻录必究 .
请输入账号
请输入密码
请输验证码
